Just a little update:

We bust the ceiling down some more to run more wires, get ready to start running the duct, and put up the fans. I purchased most of the lights and nick nacks for the room, just a few small things left to buy. Chose to go with floor board heating with a wall controller. So the three heat sources will be, the floor board, fire place (fake), and the heater connected to the fresh air duct, which is controlled by a thermostat. Next week we should have a nice update with all ducts and fans up in the ceiling. Below are a few photos.

Ceiling busted up.






Lights, and floor board heaters.



Some of the duct needed for the job.



Thanks for all comments and suggestions fellas!