My Newair Build from other site.

[Trackmyer]

Here at last....wooohooo..finally can start my build....yeah

So here is pics...and since most pics I have seen of peoples builds never really shown a clear image of what the backs of these look like, yep, you guessed it..rear end shots too.



After doing the inside wash/wipe to remove plastic smell I started build with rerouting the condensate drain back into unit. Drilled a 1/4" hole and routered out to fit a 3/8" Jon Guest line. Wanted it to be tight from start and easier when sizing it by hand.




Placed a drip tray from a 2 select capp machine in bottom to catch condensate


Now to get control center started. Installed Temp Controller, an RH controller, and already had fan controller mounted, so mounted a fan in bottom to suck in cool air into box to keep controllers cool.



Once wired up, drilled and mounted temp controller thermistor probe inside wineador a few inches from top.
Power for wineador is controlled by controller (obviously).





Any break in power to wineador causes it to reset to lowest setting, the controller will kill power to unit if it drops below 64'F. And turn it back on once it climbs above.
This will at least buy me time till I get home to reset wineador to desired program temp.

At this time fan controller is only powering 1 fan (inside control center), and monitoring temp of control center as well.


Based on closer inspection the thermistor of the wineador is not inside unit, I will inspect more later but based on temp reading it is in peltier set.
I placed two of my wireless hygrometers inside and top one is reading right on what my controller temp probe is reading 67.8'f.
The wineadors peltier is reading 65'f
Now I will let it run for night and check in morning to see if evens out.


I threw in a couple boveda 72's for night, and will pick up build in morning...Thats all for today..